NunesMelnick83

The Xbox 360 is already an amazing package alone. However, with games like Cod 5, Modern Warfare, and Modern Warfare 2, more and more people find reasons to get a new said game console, or its accessories. One particular modification can be a response to create a rapid fire modded Xbox controller. Here are the steps concerning how to modify your original controller to a rapid fire controller.

Step one. Unscrewing the controller

Modded controllers - Before you start taking your controller apart, take a critical look at the controller first and try to remember which parts go where because you will eventually must put everything back again. Start by unscrewing every one of the visible screws in the dust. After this, before you decide to tug on the case, remove the batteries to reveal the hidden screws. Remove these as well.

2. Preparing the Case

Using the controller facing down, slowly and punctiliously separate the front half of the casing from your circuit board. A dent in case will eventually should be made. Consider this before putting things back.

3. Placing The Rapid Fire Button

While other methods of modifying the controller don't involve installing of a new button, this kind of guide does. Not only does this provide help to adjust the speed of rapid fire, it minimizes tampering along with other parts of the circuit board, thereby minimizing the chance of damaging your modded Xbox controller.

Modded controllers - Remember, kits for your rapid fire controller can be purchased easily. It's the button using this kit which will be placed through the hole inside the casing, so place it gently before the circuit board is returned. You may have to snip out several flaps to produce way for the wires with the kit. You can do this with whether cutter or even a couple of scissors.

Step four. Soldering

Let's assume that you are aware how to properly start using a soldering iron, attach the red wire towards the leftmost pin of the 4-pin horizontal series, while the blue wire solders towards the rightmost pin of the identical series. The black (or green in some cases) wire attaches to the middle of the three vertical series off to the right from the switch.

Soldering is regarded as the crucial the answer to making the modded Xbox 360 console controller. This is because mistakes made in this stage can permanently damage your controller.

Step 5. Putting everything back

Modded controllers - Carefully considering the wires, try to close the circuit board and the casing. Pest little tricky as the new wires are certain to get in the form of things. Find a way for these wires to occupy the empty spaces instead of protruding. You might contain the modded Xbox controller facedown so the buttons don't fall and maneuvering the wires really are a little easier. Put the casings together but don't return the screws yet. You now have to check if the rapid fire buttons work. Should they don't, you may need to restart both your console as well as the now modded Xbox 360 console controller. This should solve the issue. When it doesn't then you can need to go with the steps again to check.