IzaguirreMcvay301

The Xbox 360 is already an incredible package alone. However, with games like Cod 5, Modern Warfare, and Modern Warfare 2, more and more people find top reasons to modify the said game console, or its accessories. One modification is really a reaction to create a rapid fire modded Xbox 360 console controller. Listed here are the steps regarding how to modify your original controller to a rapid fire controller.

Step 1. Unscrewing the controller

Modded controllers - Before you begin taking your controller apart, have a critical look at the controller first and attempt to remember which parts go where since you will eventually have to put everything again. Begin by unscrewing all of the visible screws at the back. After this, prior to deciding to tug on the case, remove the batteries to disclose the hidden screws. Remove these as well.

2. Preparing the situation

With the controller facing down, slowly and carefully separate the leading 50 % of the casing in the circuit board. A dent in case could eventually are necessary. Remember this before putting things back.

Step 3. Placing The Rapid Fire Button

While other methods of modifying the controller usually do not involve installing of a fresh button, this specific guide does. Besides this provide help to adjust the speed of rapid fire, it minimizes tampering with other areas of the circuit board, thereby minimizing the risk of damaging your modded Xbox 360 console controller.

Xbox 360 modded controllers - Remember, kits for your rapid fire controller can be purchased easily. It's the button using this kit that will be placed with the hole in the casing, so place it gently ahead of the circuit board is returned. You might want to snip out a couple of flaps to produce means for the wires from the kit. You can do this with either a cutter or even a set of scissors.

Step four. Soldering

Let's assume that you know how to properly use a soldering iron, attach the red wire for the leftmost pin of the 4-pin horizontal series, as the blue wire solders to the rightmost pin of the identical series. The black (or green sometimes) wire attaches for the core three vertical series off to the right of the switch.

Soldering is the most crucial key to making the modded Xbox 360 console controller. This is because mistakes made with this stage can permanently damage your controller.

Step 5. Putting everything back

Mod controller - Carefully taking note of the wires, make an effort to close the circuit board as well as the casing. This may be a little tricky as the new wires are certain to get in the way of things. Find a way because of these wires to occupy the empty spaces as opposed to protruding. You could hold the modded Xbox 360 controller facedown so the buttons don't fall and maneuvering the wires certainly are a little easier. Position the casings together but don't return the screws yet. Congratulations, you have to see if the rapid fire buttons work. If they don't, you may have to restart both your console as well as the now modded Xbox controller. This would solve the issue. When it doesn't then you can need to go through the steps again to double check.