Quelltext der Seite Techniques for Controlling the Temperature of a Bearded Monster Cage/Vivarium

Possibly the single most asked about issue for new [http://www.beardeddragoncenter.org Bearded Dragon Diet] keepers is just how to get the temperature set up correctly in the vivariumIt is fairly a difficult thing to get right at the start, and due to this it's usually suggested that you set up the vivarium and have it working for about weekly before you get your bearded dragon. Small adjustments while you are working it out may cause the temperature to shoot up, or down, which may not make for a very relaxed beardie if it was occupied while you were enjoying around.The initial thing to take into account is where you set up the vivarium. You don't want this to be in direct sunlight, or in a location that gets lots of draughts as your temperatures will be caused by this to vary. Placing it in a sheltered, shady the main space is a good start.Bearded dragons need to be able to thermoregulate - they'll bask until they are too hot, and then they will escape to a cooler place to cool-down. You therefore have to have a basking position with a of around 105f (41c), and at the other end of the vivarium it should be cooler, with a temperature no more than 85f (30c). Below this is fine.To do this you'll have to have a warmth emitting lamp at the 'hot end.' Beardies are interested in bask under bright lights, therefore a pleasant bright spotlight of 60 or 100 n is ideal. You do not have to buy the high priced ones in dinosaur retailers - a normal house one of the right wattage will undoubtedly be fine. Ceramic lamps which give off number light are adequate, but the bearded dragon may not be so drawn to basking under it. Nevertheless, certainly one of our beardies has often had a basks wonderful and ceramic bulb. Ceramic lamps also provide the bonus you may turn down heat during the night with out a light disturbing his rest. Nevertheless, many homes are warm enough to ensure that bearded dragons require no extra heat during the night - as long as your house doesn't fall below 60f (16c) for a person, or 65f (18c) for a juvenile. Bearded dragons require a good temperature decrease at night in order to get a good sleep.The temperature must certanly be handled by the heat lamp will be turned by a thermostat which on or off to keep up a regular heat. The kind of light you select may influence which thermostat you should buy. A dimming thermostat steadily lowers and increases the power to the light, a pulsing thermostat changes it on and off. If you've a heat light then a dimming thermostat is essential otherwise you'll keep coming the bulbs. A pulsing thermostat can be described as a little cheaper, and can be used with ceramic bulbs.The key thing to remember is that the thermostat should be used to keep the cool end cool. The basking area may be the actual position the beardie will lie to bask. This can be modified later, and by introducing stones of offices you can raise or lower the basking location until it's at the right temperature. It's maybe not the whole of the 'warm end' of the vivarium that you are hoping to get to that high.Place the probe of the thermostat near the great end of the viv, switch on the heat, and keep for a couple hours. An excellent electronic thermometer with dual inputs and a dual readout is great if you are in a position to see the conditions at the cool end and the basking position at the same time. You're looking for the great conclusion to be below 85f (30c), and for the basking position to be 105f (41c). If the great end is right, gauge the temperature at the basking area, and include your stones or twigs or take them away to try to access 105f (41c). If the great end is lower than 85f (30c), and you cannot get the basking place heat up, more the probe slightly towards the heart of the vivarium. Again, permit to stay for a couple hours before examining the dimensions again. You should carry on this until you have the correct conditions at the great end. It generally does not matter if the great conclusion is below 85f (30c ).Once you have got the conditions right, leave and stop fiddling. Wait a couple of days and then check always again. Ensure you have the UVB tube on at the same time as this may produce just a little warmth itself.If you find your vivarium is too hot, and you can't get the temperature at the great end low enough, check whether there are adequate air vents in the back. There must be at least one at each stop - one towards the utmost effective, and one towards underneath. Extra vents can be added by you if necessary.If the temperature is too high because it is at the center of summer you must look into buying a diamond fan. Another thermostat can get a grip on this, and it can be developed to kick in when the temperature goes above a specific level.Once the probe is in the appropriate spot, your temperatures have stablised, you shouldn't need certainly to modify the settings. It's simple to introduce your bearded dragon to its new home.